Chapter 242

Carrying a box out of the warehouse, the hands of light floating is tens of millions.

Lu Li smiles and shakes his head. Jade carving is such a luxury. Any piece of material is very valuable.

If you make a mistake, it will hurt your heart.

Carrying the box back to the jade carving studio, Lu Li sat down in front of a jade carving processing equipment.

Carefully take out this Tianhuang stone from the box, and carefully install it on the jade carving equipment, lock the soft clamp, and carefully fix the jade.

Not careful! This thing It's too expensive!

After the installation and fixation, Luli turned on the dust blower on the jade carving equipment and was ready to re observe the jade.

Turn the fixture and keep changing the angle. Turn on the light and check it again to make sure there is no problem with your design.

"Then Let's go

Press the start button, jade carving equipment immediately run up, the rapid rotation of the motor sounded a slight "buzz" sound.

Reach out and pick up the electric carving needle, and use the way of line carving to gently carve lines on the jade to depict the modeling composition.

The carving needle fell on the jade and the dust turned up. The dust is sucked clean by the dust suction fan in an instant.

When the tracing is finished, there are at least one or two grams of jade dust, and hundreds of thousands of them are gone!

Of course, once Lu Li has finished carving and made a successful work, he can immediately double the original material value of the jade.

Turn off the cutting needle, change the grinding head, and Lu Li begins to peel!

In addition to the reserved jade skin, other parts of the jade skin should be stripped to reveal the crystal clear texture of the jade.

The grinding head should be wiped a little bit, polished a little bit, polished very slightly and carefully. It must be ensured that the material can not be wasted and too much can not be cut off.

After polishing, it is rough carving.

On the basis of composition and engraving, according to the natural characteristics of jade, it is appropriate to build a perfect shape.

Another carving needle was used to polish the surface of the jade to build a three-dimensional shape.

When Lu Li used a needle to carve on a black spot of tianhuangshi's original flaw, just as he put the needle in, Lu Li suddenly gave a blow to his wrist.

"Lying trough!"

Even with Lu Li's "calmness", he could not help but scold.

Through the peeling jade skin, the light shines on the translucent jade. Lu Li sees that behind the black spot, suddenly A deep crack appeared.

The jade has cracks! Or the crack deep inside the jade!

If there is a crack inside a jade, this fatal flaw will inevitably lead to a sharp drop in the value of the jade.

This is the risk of the jade industry!

A piece of jade. It looks perfect on the surface. When it was processed, it was found that there were cracks inside.

This kind of internal crack is difficult to find in the detection and identification of jade.

As a jade carving craftsman, I am most afraid of this situation. Jade is very brittle. It is more dangerous to carve jade with cracks. If you are not careful, it may lead to crack propagation and complete fragmentation of jade.

Lu Li stopped, looked up and called out, "manager Wu, come quickly!"

"What can I do for you, Miss Lu?"

Manager Wu rushed in.

"See for yourself!"

Lu Li pointed to the jade on the jade carving equipment and said to manager Wu, "there are cracks! Internal crack

"Ah?"

With a cry of surprise, manager Wu quickly came up and looked down. Sure enough, I saw a tiny line mark inside the jade, which was a crack.

"This This... "

Manager Wu had no choice but to say, "Mr. Lu, look This What shall we do? "

The value of a cracked jade carving has plummeted!

"There's a way, hollow out!"

Lu Li pointed to the crack on the jade. Manager Wu of Chao Dynasty said: "through the hollowing out process, this crack is integrated into the modeling composition to perfectly solve the crack problem. It's just There are risks. "

"What risk?"

After all, manager Wu is not a professional and is not very expert in specific operations.

"If there is a crack, it means that there is an internal stress. It is not certain whether the stress is completely relieved. So If you go down with a knife, it is likely that this jade will be broken. "

Lu Li hands a stand, "jade is yours, take this risk or not, it's up to you."

If the jade is broken, the loss will be heavy.

Although small pieces of jade are still valuable, but The value of small pieces of jade is not the same as that of large pieces.

"I I'll make a phone call

Manager Wu didn't dare to be the master, so he quickly took out his mobile phone and dialed the boss's phone. "Mr. Jiang, Mr. Lu, in the process of carving, found a crack inside No. 3 tianhuangshi. yes! Internal cracks. What Miss Lu means Would you like to speak to Mr. Lu? All rightManager Wu quickly handed the phone to Lu Li.

"Hello, Mr. Jiang."

Lu Li took the phone and said hello to President Jiang.

"How are you, younger martial brother!"

Mr. Jiang said with a smile, "younger martial brother, when are you free? Let's get together! I've cooperated with our company twice. I haven't had time to meet you yet! "

"Well Mr. Jiang, you're welcome! "

Lu Li Leng for a moment, now is not the problem of jade? What do you do?

"Mr. Jiang, this tianhuangshi..."

Lu Li was about to explain the situation, but before he finished, he was interrupted by President Jiang.

"Just do it as you see fit!"

Mr. Jiang said with a smile, "the teacher appreciates your skill very much. I believe in the teacher's vision and your skills. Do what you want. "

"What if it breaks?"

Lu Li is not sure. There is no solution to the internal stress of jade.

"Ha ha! If it's broken, sell it as a snack! "

Mr. Jiang said with a smile, "even if it's broken, you can make small carvings with your skill."

"That's fine!"

Lu Li nodded with a smile, "I'll have a try!"

Since you believe me so much, I have to show some real skills.

Hang up the phone, Lu Li returned the mobile phone to manager Wu, "President Jiang said, let me handle it, I'll do my best!"

"OK, please, Miss Lu."

Manager Wu answered the phone and nodded to Luli, "Miss Lu, I won't disturb you. I'll go out first."

When manager Wu left, Lu Li looked at Tian Huangshi and the hidden crack, and breathed a long breath.

Mr. Jiang's words are not only his trust in me, but also his contribution to my army!

If you can't solve this problem perfectly, I'm sorry for Han's praise!

Internal stress, right? Isn't it just a mechanical problem?

For Xueba, this is a problem!

Lu Li turned and walked to the next desk, took out a pen and paper, drew a picture, calculated the stress direction, calculated the stress size.

There are professional data on the hardness and density of tianhuangshi, which is not very complicated.

Writing incessantly, Lu Li quickly calculated the direction and magnitude of stress. Of course, it's just an estimate.

Without destroying the structure, there is no way for the whole world to eliminate the internal stress of jade. It can only be handed over to nature and time.

However Jade carving is to destroy the internal structure and release the internal stress.

After the calculation, Lu Li had a good idea.

Sitting on the jade carving equipment again, Lu Li took a long carving needle, took a deep breath, aimed at the location of the crack, and slowly pressed it down.

The rapid rotation of the carving needle, into the jade, burst out a burst of toothache friction sound.

Carefully press the carving needle, the rapidly rotating tip of the needle, the moment it touches the crack, Lu Li's heart is raised.

It's not broken!

Cut the needle into the crack, the jade is not broken!

Hoo

Lu Li took a long breath, and a smile appeared on his face. Sure enough, my calculation is completely correct. Even if there is still internal stress, it has been released.

The next step is to test the craft!

Hollow jade carving is the most challenging carving technique in jade carving.

Lu Li replaced the thinnest and longest carving knife and went deep into the hole. Taking the black spots on tianhuangshi as the origin, he used the holes and cracks to carve the shapes of underground river, waterfall and deep pool.

Compared with the original landscape ornaments, the newly added hollow carving will definitely consume more materials, but It not only makes up for the crack, but also shows its skill and originality.

This kind of carving, which is similar to micro carving, must be extremely careful. The hand should be very stable and the heart should be very quiet. If you make a little mistake, all previous achievements will be wasted.

Fortunately, Lu left and hung up!

Dexterity makes Lu Li's hands very flexible and stable. Calm let Lu Li's state of mind is very calm, very calm, not in a hurry, not impatient.

It took a long time for Lu Li to finish the fine carving.

The next carving is very smooth.

Modern jade carving equipment is faster than traditional technology, and the speed of polishing jade is extremely fast. Hard jade, under the rapid rotation of the carving knife, is not much different from cutting wood.

At the end of the day, Lu Li has finished the main carving process. He only needs to polish and leave the author's inscription.

At dinner, manager Wu brought a table full of food.

No wine! Jade carving craftsmen are not allowed to drink. It's easy to shake your hands when drinking Millions, tens of millions, even hundreds of millions are gone.

After dinner, Lu Li got into the jade carving studio and continued to work.The cutting tool was replaced by a polishing head to polish the surface of jade.

The newly carved jade looks grey and not pearly. Only when the polishing is finished, can it shine and shine.

The polishing head is coated with polishing powder to grind the surface of jade.

This process is to smooth the marks of the cutting tool.

After polishing and cleaning, the jade carving itself has been finished, but And we need a base for it.

This kind of jade ornament usually uses the base of ebony carving.

Base material, the company has been prepared for a long time. Lu Li chose a piece of ebony of suitable size and carved it.

The base modeling and carving must be consistent with the modeling on the jade carving.

With the skill of Luli, it's easy to finish this wood carving on the base.

After polishing and waxing the base of the wood carving, Lu Li placed the jade carving in the dent reserved on the base, and made it tight.

"Done!"

Lu Li nodded with a smile as he looked at the jade carving in front of him.

……

The next day.

Lu Li's jade carving was officially released.

"Miss Lu, your work Has it been completed? "

Seeing this beautiful jade carving, manager Wu exclaimed, "Mr. Lu, you are so amazing! The crack is completely invisible, completely gone. wonderful is one's art! It's amazing

Manager Wu quickly took out his mobile phone and dialed President Jiang, "President Jiang, teacher Lu's work is finished. yes! I can't see the crack at all. It's amazing! "

Hang up, manager Wu said to Lu Li, "Mr. Lu, Mr. Jiang will come right away. He wants to enjoy your creation."

"Welcome, welcome!"

Lu Li smiles. It's normal for the boss to have a look at the jade carving in person when it's finished.

A moment later, a middle-aged man in his forties, who looked very dignified, walked into the jade carving workshop with a smile on his face.

"Mr. Jiang!"

Manager Wu went up to say hello.

"Ha ha! Younger martial brother, I heard that you have finished the creation? "

General manager Jiang nodded to manager Wu, and then came to Lu Li with a smile on his face.

"Good ginger!"

Lu Li said hello with a smile.

"Elder martial brother! Call elder martial brother

Mr. Jiang said with a smile, "I'm also a student of Han Lao. In sum, I'm your elder martial brother. You'll be surprised if you call Mr. Jiang! "

"Hello, elder martial brother!"

Lu Li followed the good advice and quickly changed his voice and called for elder martial brother.

It's just Lu Li also knows that this kind of "elder martial brother" is just talking about it. It's not a concept at all with the elder martial brother in ancient times.

"Good! Good

President Jiang nodded with a smile and looked at the finished jade carving. "This jade carving Good craftsmanship, good craftsmanship, younger martial brother is really superb! Is the internal crack changed into a waterfall? Good, good! "

"The crack is carved into waterfall, dark river and cold pool by hollowing out technology."

Lu Li laughed, reached for a bottle of mineral water on the table, unscrewed the cap and filled it with a little water. "Brother, please see, this is a real waterfall!"

With that, Lu Li poured the water into the cold pool on the jade carving.

And then A little water gushed out and the waterfall appeared. The trickle is endless. Together with the jade carving ornaments in the shape of this mountain, it's so beautiful that it's interesting to see each other.

"Good! Good! The mountains and rivers match each other. Moreover, this lid water, cycle, this is Siphon principle? How powerful

President Jiang was full of praise, "little younger martial brother, this skill It's amazing

www.novelhall.com , the fastest update of the webnovel!