Chapter 15: Battle in the Philippine Sea - Unveiling (6)

Chapter 15: Battle in the Philippine Sea - Unveiling (6)

Vast amounts of heat are converging.

Countless flames gather and compress within its own body.

The fusion light intensifies in its depths.

Inside Godzillas body, the fusion reactor, which has already been compressed and heated to its limits, is once again compressed, further increasing the temperature.

The high-energy neutrons generated by nuclear fusion bombard Godzillas body, causing the inner walls of its fusion reactor to melt and sublime.

Even though the internal metal walls have been reinforced by a powerful magnetic field generated by nuclear fusion, and even though the fusion reactor has fully utilized the plasma flames to contain the energy of high-energy neutrons and radiation.

But now, at this moment, with the accumulated energy in Godzillas fusion reactor far surpassing its previous state, the inner walls of the fusion reactor inevitably begin to melt.

All the cooling fluid inside has been transported to this area. Most of the cooling fluid from the first fusion reactor has already been drained, leaving Godzilla with only the bare minimum energy for survival.

The casing is cooling at full power, and the carbon nanotubes are conducting heat at full capacity, but its all in vain. Even though Godzilla is using plasma flow to intercept most of the high-energy neutrons through collisions with extreme precision, its futile.

Because at this moment, the energy inside Godzillas body is too immense.

Godzilla doesnt have just one fusion reactor; it actually has two.

One is the power supply fusion reactor that provides energy for its movements, while the other is the breath fusion reactor specifically used for its breath attack.

The former has lower intensity and a maximum power of only a few terawatts, but it can sustain continuous output.

The latter has extremely high intensity, and its maximum power can reach several hundred terawatts.

However, it cannot sustain continuous output; it can only expel the flames of the core at the moment of ignition.

Not only are their locations different, but their principles are also completely different.

The principle of the survival reactor relies on the metal layer inside the fusion reactor, which is heated by high-energy neutrons and thermal radiation generated by fusion.

The liquid behind the indirectly heated metal layer evaporates and expands, driving the generators inside Godzillas body.

This allows the conversion of thermal energy into kinetic energy, which is then converted into electrical energy.

In simple terms, its like boiling water, except the liquid being heated is not necessarily water but some liquid metal.

Thats the working principle of Godzillas survival reactor, while the breath reactor is completely opposite.

If the survival reactor requires the nuclear reactor to heat it as much as possible to obtain energy,

The breath reactor aims to prevent the nuclear reactor from heating the metal walls and instead gathers the heat within the plasma.

Rather than releasing the heat.

As for why its done this way, its because the power of the breath reactor is extremely high.

With a maximum power of 300 terawatts, if heat transfer through the casing is used,

It can greatly reduce the number of high-energy neutrons and thermal radiation colliding with the metallic wall, minimizing self-damage to Godzilla.

With this ability, Godzilla can increase its instantaneous power to a level that previously required self-inflicted injuries.

Of course, it requires a period of charging.

Although fundamentally speaking, this cannot be called charging.

It is merely a matter of spending time adjusting the density of the plasma.

Once the density of the plasma is properly adjusted, more fuel can be added, allowing the instantaneous power to reach a terrifying level without causing significant harm to Godzilla itself.

In theory, Godzilla only needs one to two minutes to adjust the beams power.

However, it has been more than ten minutes, and it remains motionless.

As for why Well, its because

Godzilla cant activate it.

Really What should be done to achieve it? Why isnt there an auxiliary ignition?

Although the system panel has instructions on using a magnetic field to make the plasma ultra-dense.

But some things cannot be easily accomplished just by having instructions.

In the end, this is Godzillas first time attempting this, and its normal to be unfamiliar with it.

Finally, its done.

After more than ten minutes of fiddling, Godzilla feels the inner wall no longer getting hotter, realizing that it has finally adjusted the plasma density correctly.

During those ten minutes, it maintained the atomic breath reactor at power levels of tens or even hundreds of terawatts.

This greatly exceeded its capacity, resulting in the heating of its entire body and the melting of the reactors inner wall.

If Godzilla didnt have two fusion reactors and a sufficiently robust cooling structure, it would have burned itself to death during its previous attempts.

Compared to the damage inflicted by the attacks of the smaller entities outside, the damage caused by Godzillas own failed attempts is even greater.

But its fine now; Im finally ready.

I finally understand how to bind it.

On the surface of the sea, Godzilla, which was previously motionless, began to move again.

It opened its eyes, sensing the position of the human fleet.

Then, facing into the distance, it opened its mouth.

The Divine Punishment Beam emerged.Updated from novelb(i)n.c(o)m